What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 02.07.2025 01:43
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
What does a fuse do?
[image of Common-mode choke]
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
The MOV will conduct when the voltage exceeds 50% of line voltage.
A circuit breaker is similar, but is resettable.
He then describes the function of a fuse.
So, the voltage could go up to 500 volts, and the fuse will not open up.
He then asserts :
CM Punk makes John Cena’s WWE title reign interesting by delivering the Truth - Cageside Seats
so, what happens?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Why do I sweat a great deal while exercising the same on some days and not so much on others?
Upvotes:
One
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Tariff news isn't good... - Daily Kos
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
[old diagram got deleted by accident]
These are simplified answers to the original question, and does not change anything I wrote above.
the problem then depends on "how fast does the fuse operate?".
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Bat found in Downtown Boise tests positive for rabies - KTVB
nine
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Because the load is inductive, the current lags the voltage.(by a bit).
For this case there are devices called Metal oxide varistors (MOV).
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This is where the MOV conducts again, and dissipated the energy.
The other is “what does a “fuse” do?”
But it can get overloaded, and no longer works.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
2024–10–16 [ OO OLAOYE OYEBODE ]
2024–10–10[John johnson John Johnson ]
In schematic diagrams this is the symbol for a fuse:
What product failed in the market but was successful when used for something else?
There are three different concepts here that are getting confused.
but I think this circuit , shows a few more pieces.
This is 'the assistant's answer'
What are some good methods for dealing with other people's loud, crying kids on long flights?
a photo is worth a thousand words.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
His Overpriced Mustang Went Up In Flames Then Ford Mailed Him A Souvenir - Carscoops
One is “what exactly is in a ‘surge protector’ ? ”
Edit 2024–10.
Here is a simplified AC power diagram.
A father of 3 felt healthy. Then a routine screening found a rare, deadly illness. - CBS News
First Sentence:
These devices are installed between the “hot” and “neutral” and protective ground.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
At one ohm, the resistor has a maximum of 1 watt power.
Now when you have a certain ac resistance, then a current flows in a loop.
Barnstars:
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This device then solves the entire problem.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
what exactly is a ‘surge’ protector?
But… the neutral is now “floating” because of the 1 ohm resistance.
A fuse is a non-resetable over current circuit protector.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
The third is lightning and “how it gets conducted into a home.”
There are two important concepts here.
This one hit behind the barn.
but this device (an Inductor) … impedes the rapid changes in the current.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
What is lightning?
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
An AC voltage/ current source, and an ac inductive load.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
At least they know the answer if they wanted it.
It seems Mohan does not understand the difference between a comment and an Answer.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–14 [Omar Gharbi Omar Gharbi ]
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
The bolt then partially travels down the line to your home.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
He then describes Rainy Season and Lightning.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
(Dc diagram shown, AC is similar).
I post the exact comment here.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
eight
It also is a device that limits the change in current flow.